Heating Installation - 6 Things You Should Do Before You Install a Heating System

Heating installation can range from simple tasks like relocating a wall heater to more complicated projects like installing a new central heating system. Whatever the case, installing a new heating system is an investment that can pay for itself many times over by keeping your home comfortable and cozy.

In general, if your furnace is starting to give you trouble, it's time for a replacement. But, before you jump into a whole new system, there are a few things you should do first.

1. Determine the best type of heating for your home

There are a variety of ways to heat your house, from natural gas and oil to electricity. And, while some heating systems are better suited for certain homes than others, all of them can provide adequate, efficient heat and save you money on utility bills. This page has more information about hvac company for heater.

2. Select the best wiring for your heaters

A 240-volt circuit provides lower amperage than a 120-volt circuit, and is preferred by electricians when adding baseboard heaters.

3. Installing a new 240-volt heater is straightforward, as long as you have the proper wiring and tools to do it safely.

4. Using a stud finder, locate and mark at least two studs behind the baseboard heater (the ends that stick out of the floor or the wall) where you'll attach the unit. Use one 5/8-inch drywall screw to fasten the heater to each stud.

5. Connect the wires from the heater to the wiring compartment on the back of each unit.

If you have a single unit, it's easy to install a wall heater by yourself; however, if you're going to have more than one, a professional will probably be able to do the job faster and easier.

6. Hook up the wires to a thermostat box

Once you've located and marked the thermostat's location, assemble the necessary wiring. For each thermostat, you'll need a 2-wire circuit (#14 for 15 amp circuits or #12 for 20 amp circuits) of NM type (Romex) or similar cable from the electrical panel to the thermostat location.

Strip about 3/4 inch of insulation from each conducting wire from both cables in the thermostat box. Following the thermostat manufacturer's instructions, connect the wire leads labeled "line" to the wires entering the box from the service panel and "load" to the wires running to the baseboard heater.

8. Make sure the bare copper grounding wire is connected to the green grounding screw in the heater connection box.

9. Check the volts and wattage usage of your wall heaters

When you're ready to install an electric wall heater, be sure to check the volts and wattage usage on the thermostat before starting. This will help you avoid accidentally reversing the direction of a power circuit. If you need better a/c, visit this page.

If you're unsure of how to do this, contact an electrician. They can help you figure out how to correctly connect the 240-volt circuit to the heater, and verify the wattage is within the limits of your new circuit. It's good to visit this site for more information about this topic: https://en.wikipedia.org/wiki/Heating_system.